Checkline NE214 Betriebsanleitung Seite 39

Enter code
Wrong code
Correct code unknown
Correct code
Change operating parameters
Line 1
Line 2
Line 3
Line 4
Line 5
Line 6
The method of accessing the programming mode is described be-
low, together with the three programming segments in the order in
which they are used.
To access programming
➜ Press the key.
● The system transfers from the operating to programming mode.
➜ Press the
key. „CodE" is displayed.
The code applies to programming segments 1-3.
Enter with the keys
No code is entered before delivery.
If an incorrect code is entered, then „Error" appears in the display
(as long as the key is pressed). After 15 s the system automati-
cally switches back to the operator level.
➜ Press the key, then press
If the correct code is not known: Return the counter to the factory.
➜ When the correct code has been input, press the
● The programming segments are now called up in succession.
Programming segment 1
Information on the displays and changing individual values is also
given in section 4.
➜ Press the
key again.
● The operating parameters are now called up.
The respective LED flashes.
➜ Input the new value with the
XP - Current counter status
P1 - Preset value 1
P2 - Preset value 2
SC - Start count value
∑ - Totalizer
- Hours counter
The dashed line represents the end of the first program field.
www.checkline.eu
and . Press the
key and enter the correct code.
und
NE214
key to acknowledge.
key.
keys.
39