Troubleshooting - Kenwood DAB400U Bedienungsanleitung

TROUBLESHOOTING

Symptom
Sound cannot be heard.
"MISWIRING CHECK WIRING
THEN PWR ON" appears.
"PROTECTING SEND
SERVICE" appears.
• Sound cannot be heard.
• The unit does not turn on.
• Information shown on
the display is incorrect.
The unit does not work
at all.
DAB reception is poor.
"DAB ANT ERR"
"RELATED SERV FOUND"
• Radio reception is poor.
• Static noise while
listening to the radio.
Disc cannot be ejected.
Noise is generated.
14
Remedy
• Adjust the volume to the optimum level.
• Check the cords and connections.
Turn the power off, then check to be sure the
terminals of the speaker wires are insulated properly.
Turn the power on again.
Send the unit to the nearest service center.
Clean the connectors. ( 15)
Reset the unit. ( 3)
Make sure [ON] is selected for [DAB ANT POWER].
( 4)
Check the DAB antenna. If a passive antenna (without
a booster) is used, set [DAB ANT POWER] to [OFF].
( 4)
• Press the volume knob to activate Soft-Link. ( 7)
• Press
to cancel.
Connect the antenna firmly.
Press and hold M to forcibly eject the disc. Be careful
not to drop the disc when it is ejected. If this does not
solve the problem, reset the unit. ( 3)
Skip to another track or change the disc.
Symptom Remedy
Tracks do not play back as Playback order is determined when files are recorded.
you intended them to play.
"READING" keeps flashing. Do not use too many hierarchical levels or folders.
Elapsed playing time is not This is caused by how the tracks are recorded.
correct.
• This unit can only display uppercase letters, numbers,
Correct characters are not
displayed (e.g. album
• Depending on the display language you have selected
name).
"NA FILE" Make sure the disc contains supported audio files.
( 15, 16)
"NO DISC" Insert a playable disc into the loading slot.
"TOC ERROR" Make sure the disc is clean and inserted properly.
"PLEASE EJECT" Reset the unit. If this does not solve the problem,
consult your nearest service center.
"READ ERROR" Copy the files and folders onto the USB device again. If
this does not solve the problem, reset the USB device or
use another USB device.
"NO DEVICE" Connect a USB device, and change the source to USB
again.
"COPY PRO" A copy-protected file is played.
"NA DEVICE" Connect a supported USB device, and check the
connections.
"NO MUSIC" Connect a USB device that contains playable audio files.
• Reconnect the iPod.
"iPod ERROR"
• Reset the iPod.
and a limited number of symbols.
( 5), some characters may not be displayed
correctly.