Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
E N G L I S H
• The cable wire colours, or a letter, will be
marked at the connection points of most good
quality plugs. Attach the wires to their respective
points in the plug (see below). Brown is for Live
(L) (2) and Blue is for Neutral (N) (4).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminal screws.
Never use a light socket.
Never connect the live (L) or neutral (N)
wires to the earth pin marked E or
For 115 V units with a power rating exceeding 1500 W,
we recommend to fit a plug to BS4343 standard.
Using an extension cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data). The minimum conductor
size is 1.5 mm
. When using a cable reel,
2
always unwind the cable completely.
Also refer to the table below.
Conductor size (mm
)
2
0.75
1.00
1.50
2.50
4.00
Voltage
Amperes
115
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
14
Cable rating (Amperes)
6
10
15
20
25
Cable length (m)
7.5
15
25
30
45
Cable rating (Amperes)
6
6
6
6
6
6
6
6
15
6
6
10
15
20
10
10
15
20
20
15
15
20
25
25
20
20
25
-
230
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
Assembly and adjustment
Replacing the saw blade (fig. B & C)
• Using the Allen key (2) supplied with the tool,
loosen the saw blade fixing screw (7).
• Insert the saw blade (5) into the holder (4) until it
engages in the lock pin (9). The blade can be
installed with the teeth pointing down or up.
• To remove the saw blade, proceed in reverse order.
• Place the Allen key (2) back into its holder.
.
Saw blades
material
ferrous metal
non ferrous metal
wood
plastic
masonry
A wide variety of dedicated saw blades is available
as an option.
Instructions for use
• Always observe the safety instructions
60
• Ensure the material to be sawn is secured in place.
• Apply only a gentle pressure to the tool and do
6
10
not exert side pressure on the saw blade. If possible,
15
work with the saw shoe pressed against the
20
workpiece. This prevents damage to the blade
25
and stops the tool from jerking and vibrating.
-
• When sawing in walls or floors be aware of the
location of pipework and wiring. Always hold
-
-
thetool by its handle.
0 - 2.0
6
6
6
6
6
6
10
10
10
15
15
15
20
20
20
Prior to assembly and adjustment always
unplug the tool.
recommended saw blade
fine-toothed
coarse-toothed
TCT saw blade
fine-toothed
carbide-tipped
Always select your saw blade with great
care.
and applicable regulations.
6
6
6
6
6
6
6
6
6
6
10
15
10
15
15
15
20
20
20
25
-
- Quicklinks:
- Deutsch
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
