Frost Precautions; What To Do If - Electrolux GA55GLV402 Benutzerinformation

92 electrolux
3. Clean the spray arm and the fixing screw.
4. Attach the spray arm with the fixing screw
by turn it clockwise.
External cleaning
Clean the external surfaces of the appliance
and control panel with a damp soft cloth.

What to do if...

The appliance does not start or stops during
operation.
If there is a fault, first try to find a solution to
the problem yourself. If you cannot find a sol-
ution to the problem yourself, contact the
Service Force Centre.
Fault code and malfunction
• intermittent audible signal
• digital display shows
The dishwasher does not fill with wa-
ter
• intermittent audible signal
• digital display shows
The dishwasher will not drain
• intermittent audible signal
• digital display shows
The anti-flood device operates
The programme does not start
After the check, switch on the appliance. The
programme continues from the point of in-
Only use neutral detergents. Do not use
abrasive products, scouring pads or solvents
(acetone, trichloroethylene etc...).

Frost precautions

Caution! Do not install the appliance
where the temperature is below 0 °C.
The manufacturer is not responsible for
damage because of frost.
If not possible, empty the appliance and
close the door. Disconnect the water inlet
hose and remove water from the water inlet
hose.
Caution! Switch off the appliance
before you do the below suggested
corrective actions.
Possible cause and solution
• The water tap is blocked or furred with limescale.
Clean the water tap.
• The water tap is closed.
Open the water tap.
• The filter in the water inlet hose is blocked.
Clean the filter.
• The connection of the water inlet hose is not correct. The
hose can be kinked or squashed.
Make sure that the connection is correct.
• There is a blockage in the sink spigot.
Clean the sink spigot.
• The connection of the water drain hose is not correct. The
hose can be kinked or squashed.
Make sure that the connection is correct.
• Close the water tap and contact your local Service Force
Centre.
• The appliance door is not closed.
Close the door.
• Mains plug is not connected in.
Put in the mains.
• The fuse has blown out in the household fuse box.
Replace the fuse.
• Delay start is set.
Cancel the delay start to start the programme immediately.
terruption. If the malfunction shows again,
contact your Service Force Centre.