Entsorgung; English; Connecting To The Mains - Bosch AdvancedAquatak 150 Originalbetriebsanleitung

OBJ_BUCH-2737-001.book Page 11 Wednesday, July 27, 2016 11:15 AM

Entsorgung

Hochdruckreiniger, Zubehör und Verpackungen sollen einer
umweltgerechten Wiederverwertung zugeführt werden.
Werfen Sie Hochdruckreiniger nicht in den Hausmüll!
Nur für EU-Länder:
Gemäß der Europäischen Richtlinie
2012/19/EU über Elektro- und Elektronik-
Altgeräte und ihrer Umsetzung in nationales
Recht müssen nicht mehr gebrauchsfähige
Elektro- und Elektronikgeräte getrennt ge-
sammelt und einer umweltgerechten Wieder-
verwertung zugeführt werden.
Änderungen vorbehalten.

English

Safety Notes
Explanation of symbols
General hazard safety alert.
Never direct the water jet
at people, animals, the
unit or electric compo-
nents.
Warning: High pressure jets can be dan-
gerous if subject to misuse.
According to the applicable
regulations, the appliance
must never be used on the
drinking water network without a
system separator. Use a separator as
per IEC 61770 Type BA.
Water flowing though a system sepa-
rator is considered not drinkable.
The AdvancedAquatak 150 is in-
tended for use only in premises
≥100 A
having a service current capacity
≥100 A per phase, supplied from a dis-
tribution network having a nominal volt-
age of 230 V. If in doubt please contact
your Supply Authority.
Bosch Power Tools
Safety Notes for pressure washer
Read all safety warnings and
all instructions. Failure to fol-
low the warnings and instruc-
tions may result in electric shock, fire
and/or serious injury.
The warning and information signs
attached to the unit provide impor-
tant information for safe operation.
Apart from the information in the op-
erating instructions comply with the
general safety regulations and regu-
lations for the prevention of acci-
dents.

Connecting to the mains


The voltage indicated on the rating
plate must correspond to the voltage
of the power source.

We recommend that this equipment
is only connected into a socket which
is protected by a circuit-breaker that
would be actuated by a 30 mA residu-
al current.
 Remove the plug from socket when-
ever the machine is left unattended
for any period.
 The electric supply installation
should comply with IEC 60364-1.
 If the supply cord is damaged, it must
be replaced by the manufacturer, its
service agent or similarly qualified
persons in order to avoid a hazard.

If the plug is damaged, pay attention
to the following:

Plugs and sockets situated near the
work site or outdoors should be to
class IP 55 of BS 5490 to provide ad-
equate protection against ingress of
English | 11
F 016 L81 291 | (27.7.16)