Safety Regulations; Proper Use - EINHELL BT-BD 801 E Bedienungsanleitung

Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.

1. Safety regulations

The corresponding safety information can be found
in the enclosed booklet.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
1.1 Special instructions for the laser
Important: Laser radiation
Do not look into the beam
Laser class 2
Never look directly into the laser path.
Never direct the laser beam at reflecting surfaces
or persons or animals. Even a low output laser
beam can inflict injury on the eye.
Caution: It is vital to follow the work procedures
described in these instructions. Using the
equipment in any other way may result in
hazardous exposure to laser radiation.
Never open laser module.
When the tool is not going to be used for an
extended period of time, the batteries should be
removed.
Do not make any modifications to the laser that
are designed to increase the laser's power.
The manufacturer cannot accept any liability for
damaged caused by a failure to comply with the
safety information.
2. Layout (Fig. 1)
1. Machine base
2. Pillar
3. Roller support
4. Drill table
5. Drill table clamp shaft
6. Machine head
7. V-belt
8. Motor
9. Grip knobs
10. Drill chuck
11. Spindle
12. Mounting holes
13. Folding chip guard
14. Depth stop
15. Speed control lever
16. Screw
17. Digital display
18. ON switch
19. OFF switch
20. ON/OFF switch (laser)
27. Drill chuck
3. Items supplied (Fig. 2)
Pillar drill
Drill chuck
Folding chip guard
Stop

4. Proper use

This pillar drill is designed for drilling metal, plastic,
wood and similar materials. It is intended for use in
the private sector only.
Food and harmful materials may not be processed
with the machine. The drill chuck is only designed for
use with drill bits and tools with a shaft diameter of 3
to 16 mm, and for cylindrical tool shanks. Tools with
a tapered shank can also be used. The machine is
intended for use by adults only.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
GB
15