Dmx Mode; Dmx-Protocol; Cleaning And Maintenance; Replacing The Fuse - EuroLite LED Strobe COB PRO8x20W DMX Bedienungsanleitung

DMX Mode

You can control the devices individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. The individual channels and their features are listed under DMX-protocol.
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the device will respond to the controller.
Addressing
Press the MODE button until the display shows A001. You can now set the desired address (001 - 512) via
the UP or DOWN buttons.
Controlling:
After having addressed the LED Strobe COB PRO 8x20W DMX, you may now start operating it via your
lighting controller.
Please, be sure that you don't have any overlapping channels in order to control each fixture correctly and
independently from any other fixture on the DMX-chain. If several fixtures are addressed similarly, they will
work synchronically.

DMX-Protocol

Channel DMX Value Characteristic
000-255
CH1
CH2 000-003
004-255
CH3 000-009
010-255
CH4 000-009
010-255
000-009
CH5
010-255

CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse-holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse-holder.
Step 3: Install the new fuse in the fuse-holder.
Step 4: Replace the fuse-holder in the housing.
Gradual adjustment of the dimmer intensity from 0 to 100 %
Blackout
Strobe-effect with increasing speed
Blackout
Running light, in pairs with increasing speed
Blackout
"Blinder effect" for 2 seconds
Blackout
Auto programs with increasing speed
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
22/23 00090020.DOC, Version 1.0