Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Initial Operation
In order to ensure proper commissioning, you should read these
operating instructions including the safety instructions thoroughly and
attentively before using the system.
Installation
In choosing the location to set up your camera, please note that direct intense sunlight, vibrations and dust have to be
avoided.
The device must not be set up in the vicinity of other devices with strong magnetic fields.
The camera should not be placed in the vicinity of devices with strong electrical fields, such as cell phones, radio sets and
electrical motors, et cetera. They could have a negative influence on the image quality.
Direct sunlight and/or bright illumination, et cetera may have a strong influence on the image and may make watching the
pictures more difficult. Please observe this fact when selecting the mounting place.
The recommended installation height of the camera lens (1) is approx. 1.8 m. The installation height depends on the
object to be monitored. Prior to the final installation, we recommend to connect the camera and to look at the
corresponding camera image on the monitor / TV set to make sure that the area to be monitored is shown. Please
proceed as described in the chapter on "Connecting the device" (next chapter).
Use the boreholes of the mounting base as a drilling jig. Make sure there are no electric wires, water pipes, etc where you
will be drilling.
Screw the mounting base int o place.
Screw the thread (2) of the camera down to the mounting base, and use the nut to counter the screw connection.
Connecting the device
Use a direct voltage source with a 12 Volt output as a power supply. Never try to operate the camera on any other voltage.
The direct voltage source has to be able to supply a minimum current of 150 mA.
The camera is connected to the monitor / TV set by means of a BNC connector. The camera has been provided with a low
voltage socket for power supply.
Connectors:
BNC-connector (3):
Low voltage socket (4): voltage
Connect the direct voltage source up to the low voltage socket (4). The direct voltage source has to be switched off.
Connector: 5.5 / 2.1 mm. Please make sure that the voltage is polarised correctly.
Connect the video input up to the BNC connector (3). If your monitor / TV set has been equipped with a cinch socket only,
use an adaptor (BNC connector to cinch).
Operation
After connection of the video output and the power supply, the camera is ready for operation.
Switch the direct voltage source on. Switch your TV set or the monitor on and select the input to which the camera is
connected (such as AV input on the TV set).
The picture of the camera will appear on the screen. In the unlikely event that no picture appears on the screen or another
malfunction occurs, immediately switch off the operating voltage and the TV set / monitor, and check once again by using
the "Troubleshooting" check list in these instructions.
The camera has been optimally balanced at the factory. If you would like to balance the camera individually, use the
following procedure:
Open the camera body by turning the lens cover. Then loosen the set screws 1 and 3.
Seite 5 von 9
Video
1.
Zoom: 3.6 to 8 mm +/- 5 % – Viewing angle 3.6 mm 92°, 8 mm 40°
2.
Aperture setting for adaptation of the background illumination
3.
Image definition/focus
After making the adjustments, tighten the set screws 1 and 3 again.
Werbung
