Ordering Information; Technical Data - Camille Bauer SINEAX DME 406 Betriebsanleitung

4. Ordering information

DESCRIPTION
1. Mechanical design
Housing T24 for rail and wall mounting
2. Rated frequency
50 Hz (60 Hz possible without additional
error; 16 2/3 Hz, additional error 1.25 %)
60 Hz (50 Hz possible without additional
error; 16 2/3 Hz, additional error 1.25 %)
16 2/3 Hz (not reprogrammable by user,
50/60 Hz possible, but with additional
error 1.25 %)
3. Power supply
DC/AC 24... 60 V
DC/AC 85...230 V
4. Power supply connection
External connection (standard)
Internal from voltage input
Line 2: Not available for rated frequency
16 2/3 Hz and applications
A15/A16/A24
Caution! The power supply voltage must
agree with the input voltage (Table 2)!
5. Test certifi cate
None supplied
With test certifi cate in German
With test certifi cate in English
6. Confi guration
Basic confi guration
Programmed to order
Line 0: Not available if the power supply
is taken from the voltage input
Line 9: The fi lled form W 2410 e must
be part of the order. If primary values
of measurands and meters are required
you have to fi ll the form as well.

5. Technical data

Input
MARKING
Waveform:
406 - 1
Rated frequency:
Consumption [VA]
(at external power
supply):
1
2
Continuous thermal ratings of inputs
Current circuit
3
Voltage circuit
7
8
Short-time thermal rating of inputs
1
Input
2
Current circuit 400 V single-phase AC system
100 A
250 A
Voltage circuit 1 A, 2 A, 5 A
Single-phase
0
AC system
600 V
D
H : 1.5 Ur
intern
E
Three-phase
system
1040 V
0
H : 1.5 Ur
intern
9
PROFIBUS-DP (Bus interface RS-485)
Bus connections:
Protocole:
Protocol chip:
Transmission rate:
Addresses:
Max. length of bus:
Interface:
Confi guration
possibilities:
Sinusoidal
50, 60 or 16 2/3 Hz
Voltage circuit: U 2 / 400 kΩ
2
Current circuit: ≤ I
10 A 400 V
single-phase AC system
693 V
three-phase system
480 V single-phase AC system
831 V three-phase system
Number Duration Interval
of of between two
inputs overload overloads
693 V three-phase system
5 3 s 5 min.
1 1 s 1 hour
10 10 s 10 s
10 10 s 10 s
Screw terminals on terminals 15
to 21
PROFIBUS-DP EN 50 170
SPC 41
9.6 kBaud ... 12 MBaud
automatic baud rate recognition
126 (default), set via
Set_Slave_Address
100 ... 1200 m (dependent on the
baud rate and cable type)
RS 485, electrically insulated
(500 V)
Locally from a PC, or via bus
master
· 0.01 Ω
31