Saeco Syntia Bedienungsanleitung Seite 37

• Turn the selector dial clockwise to the
" " position.
• The following icon will be displayed:
Green
• Fill the cup with hot water to the
desired level; to stop hot water dis-
pensing, turn selector dial counter-
clockwise back to the " " position. The
machine returns to the normal operat-
ing mode.
Occasionally, after turning
the selector dial, hot water
may not be dispensed and the fol-
lowing icon may be displayed: Simply
wait until the end of the warm-up
phase, at which point hot water
will be dispensed from the wand
Orange
(Pannarello if supplied).
STEAM DISPENSING /
CAPPUCCINO BREW
ING
Steam may be used to froth milk for a
cappuccino, as well as to reheat other
beverages.
Danger of scalding! Brewing
may be preceded by small
spurts of hot water. The steam/
hot water wand may reach high
temperatures. Never touch it with
bare hands.
Important Note: After using
the steam/hot water wand
to froth milk, immediately clean
the wand (or Pannarello when pro-
vided). When the machine is ready,
dispense a small amount of hot
water in a glass and clean the steam
wand (or Pannarello when provided)
externally. In this way, all parts will
be perfectly cleaned and free of any
milk residue.
• Place a container under the steam/hot
water wand (Pannarello, if supplied).
• When the machine is ready to brew
coffee, turn selector dial counter-
clockwise to set it onto the "
tion. Residual water may dispense from
the steam/hot water wand (Pannarello,
if supplied).
• The following icon is displayed during
the preheating time required by the
machine:
Orange
• Steam dispensing will begin when the
following icon is displayed; soon after
only steam will begin to come out.
Green
• Turn the selector dial clockwise and
set it back to the " " position to stop
dispensing steam.
• Fill 1/3 of the container you wish to use
to prepare the cappuccino with cold
milk.
Use cold milk for better
results when preparing a
cappuccino.
" posi-
• 37 •