Delivery Content - HELIX P-DSP Precision Bedienungsanleitung

Connecting a computer and installing the software
To configure the signal processor manually the P-DSP must be connected to the computer. Use the USB cable
supplied to do so. The current PC Tool version is always on our homepage www.audiotec-fischer.com. The
latest version of the application is always available for download at that address. It's under "Downloads" in
the "PC Tool Software" menu. We recommend regularly checking before each use of the software for version
updates. Note that PC-Tool version updates mean that the DSP operating software must also be updated.
Pre-conditions for the use of the PC-Tool software:
Important:
Make sure the HELIX P-DSP is not connected to
your PC prior to software installation. Connect and
use it only after the software has been complete-
ly installed on your computer. To ensure fault-free
operation, always use the latest PC Tool version
available.
Software installation:
1. Download the software from the home page pre-
viously mentioned from the „Download" section
to your computers hard drive.
2. Unzip the file on your hard drive.
Important: This folder must not be on a portable
storage device such as a USB thumb drive - it
must be saved on the hard drive.
3. Double click the USB driver.exe file to start it and
install the USB interface driver. This MUST be
done before the „PC-Tool Rev X-xx.exe" program
is started.
Note: The installation may last up to one minute.

Delivery content

1 x P-DSP
18
The software is ready for use once the driver instal-
lation has completed. The P-DSP can now be con-
nected to the computer.
Note: We recommend reducing radio volume
to the minimum before first use or not connec-
ting any amplifier to the pre-amplifier P-DSP
output/s until the basic setting have been adju-
sted in the processor. Not doing so may dama-
ge any loudspeaker/s connected. Fully active
systems in particular have an inherent risk of
damage even at low volume.
Comprehensive operating instructions for the HE-
LIX DSP PC Tool can be downloaded from www.
audiotec-fischer.com
1 x Power Connector
1 x instruction
manual
1 x remote-out
cable
1 x USB Cable