General Instructions - HELIX P-DSP Precision Bedienungsanleitung

Congratulations!
Dear Customer,
Congratulations on your purchase of this high-qua-
lity HELIX-product.
With the P-DSP, HELIX is setting new standards for
digital signal prozessors.

General instructions

General installation instructions for HELIX-
components
To prevent damage to the unit and possible injury,
read this manual carefully and follow all instruc-
tions for installation. This product has been che-
cked for proper function prior to shipping and is
guaranteed against manufacturing defects.
Before starting your installation, disconnect
the batterys negative terminal to prevent da-
mage to the unit, fire and/or risk of injury. For a
proper performance and to ensure full warran-
ty coverage, we urge you to have this product
installed by an authorized HELIX dealer.
Install your HELIX P-DSP in a dry location where
there is sufficient air circulation for proper coo-
ling of the equipment. The processor should be
secured to a solid mounting surface using proper
mounting hardware. Before mounting, carefully
examine the area around and behind the propo-
sed installation location to insure that there are no
electrical cables or components, hydraulic brake
lines or any part of the fuel tank located behind
the mounting surface. Failure to do so may result
in unseen damage to these components and pos-
sible costly repairs to the vehicle.
We wish you many hours of enjoyment with your
new HELIX P-DSP.
Yours,
AUDIOTEC FISCHER
General instruction for connecting the HELIX
P-DSP processor
The HELIX P-DSP may only be installed in ve-
hicles which have a negative ground electrical
system. Any other system could cause damage
to the processor and the electrical system of the
vehicle.
Use only the enclosed cable or an EASY PLUG
cable available as an optional extra to connect
the processor to the power supply. Using any
other cable may cause damage to your system
and/or processor. The P-DSP power connec-
tion and remote control plugs may not have
any electrical contact to the metal side pane-
ling or housing as this may damage the pro-
cessor.
Prior to installlation, plan the wire routing to avo-
id any possible damage to the wire harness. All
cabling should be protected against possible
crushing or pinching hazards. Also avoid routing
cables close to potentional noise sources such as
electric motors, high power accessories and other
vehicle harnesses.
11