Change Anti Chalk Cartridge; Cleaning; Troubleshooting - Clatronic DBS 3634 Bedienungsanleitung

Change Anti Chalk Cartridge

The device indicates that the anti chalk cartridge is consumed
and needs to be replaced. When the "Anti Calc" symbol
flashes in the display, you have steam ironed for 12 hours.
The preset of the hour meter for steam ironing time
(12:00 hours) is recommended for tap water in the medium
hardness range (8.5 °dH - 14 °dH).
Depending on the hardness of your tap water the anti chalk
cartridge can be used up sooner or later. Ask you water
supplier for the hardness of the water. When the anti chalk
cartridge has lost its effect, it needs to be replaced by a new
one in order to avoid damages to the device.
CAUTION:
• Replace the anti chalk cartridge regularly, in case of
doubt, replace it rather sooner than later. Devices with
chalk damages are excluded from the liability.
WARNING:
• Always remove the mains lead before cleaning!
• Wait until the machine has cooled down completely!
• Under no circumstances should you immerse the device in water
for cleaning purposes. Otherwise this might result in an electric
shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• Clean the casing with a slightly damp cloth.
• Clean the sole plate and the rest with a slightly damp
cloth.
• Any residual water can remain in the water tank, but
should be poured out if it has been in the tank for a
prolonged period.

Troubleshooting

Fault Possible Cause
Device does Faulty mains
not work. socket.
The device Is the electric circuit
suddenly stops overloaded?
working during
operation.
DBS3634_IM
• If you do not have a new anti chalk cartridge at hand,
replace the tap water in the water tank by distilled
water. Then you can continue ironing with the used up
cartridge.
1. Turn off the appliance.
2. Disconnect the mains plug from the mains.
3. Remove the water tank.
4. Remove the anti-scale filter cartridge.
5. Install the scale filter cartridge as described in "Before
Initial Operation"
6. Before resuming the steam operation, set the hour meter
back to the starting position: Press ANTI CALC for about
5 seconds.

Cleaning

Fault
No steam is
generated.
Water leaks
from the
soleplate.
Remedy
Try another socket.
Loud noises
during steam
Check the house
operation.
fuse.
CAUTION:
"Insert Anti Chalk Cartridge".
Possible Cause
The lime filter
cartridge is mission
or has not been set
correctly.
The water tank has
not been installed
correctly.
The temperature is
set too low.
The tank is empty.
Initial start-up or
after long periods of
disuse.
Remedy
Check the position
of the lime filter
cartridge.
A "click" confirms
that the water
tank has been set
correctly.
Select a temper-
ature between
"WOOL" and
"LINEN".
Check the tank.
Fill tank with water.
These noises of the
pump are normal.
45
08.06.16