Product Elements; Noise/Vibration Information; Intended Use; For Your Safety - Bosch DL 0 607 461 001 Bedienungsanleitung

GS7461_gb_3609929796_t.fm5 Seite 2 Freitag, 7. Juli 2000 12:25 12

Product Elements

1 Tool holder
2 Housing
3 Clamping area
4 Allen screw for pressure sensing connection
5 Right/Left rotation button
6 Hanging hoop
7 Exhaust air hose (combined) *
8 Air supply hose*
9 Hose connection piece
10 Lever
11 Auxiliary handle *
12 Allen key 1/4"*
13 Round nut
14 Locking hook
15 Clutch
16 Allen key 10 mm*
*Optional accessories
Not all the accessories illustrated or described are in-
cluded in standard delivery.

Noise/Vibration Information

Measured values determined according to EN 50 144
(Rated pressure).
The typical hand-arm vibration is below 2.5 m/s
Type 0 607 461 203 / ... 204 / ... 207
The A-weighted sound pressure level of the tool is typ-
ically 74 dB(A). The noise level when working can ex-
ceed 85 dB(A).
Wear ear protection!
Type 0 607 461 001 / ... 201 / ... 202 / ... 205 /
... 206 / ... 208 / ... 209
The A-weighted sound pressure level of the tool is typ-
ically 76 dB(A). The noise level when working can ex-
ceed 85 dB(A).
Wear ear protection!

Intended Use

The machine is intended for the screwing in and loos-
ening of screws as well as for the tightening and loos-
ening of nuts in the specified dimension and
performance range.
English–2

For Your Safety

Working safely with this machine is
possible only when the operating
and safety information are read
completely and the instructions
contained therein are strictly fol-
lowed.
In addition, the Section Safety In-
structions for Pneumatic Tools
must be observed.
Before using for the first time, ask
for a practical demonstration.
Disconnect the air supply.
s
Disconnect the air supply when the machine is not
in use, before maintenance work and for the
changing of the tools.
Check the direction of rotation setting
before operating the machine!
Keep hands away from the rotating tool holder as
s
well as the tool.
Use only flawless insertion tools that are not worn.
s
Defective insertion tools can cause injuries.
Pay attention to firm seating of the insertion tools!
s
Be careful in confined working conditions.
s
As a result of the reaction torque, injuries can occur
2
.
from squeezing or pinching.
Be careful when screwing in long screws; danger
s
of sliding off.
Place the machine on the screw/nut only when
s
switched off.
Secure the workpiece.
s
Use clamping devices or a vice to hold the work-
piece in place. In this manner, it is held more se-
curely than with your hand and makes possible the
operation of the machine with both hands.
Be careful of torque reaction!
s
For high torque settings and reduced operating
pressure, the clutch no longer disengages.
It is recommended that a auxiliary handle always be
s
used to reduce the danger of injury at high torques.
Bosch can assure flawless functioning of the ma-
s
chine only when original accessories are used.