OTC CPTX 400-2w Synergy Handbuch Seite 61

GB
Function description
Additional settings:
1. By pressing the button "Set" (Pos.07) you can choose the gas pre flow.
With the potentiometer (Pos.10) you can set up your favorite value. This value is shown on
the left display. The unit [sec] is shown by the LED at the left display.
2. By pressing the button „Set" (Pos.07) you can choose the "Softstart".
With the potentiometer (Pos.10) you can set up your favorite value. This value is shown on
the left display. The unit [sec] is shown by the LED at the left display.
3. By pressing the button „Set" (Pos.07) you can choose the burn-back time.
With the potentiometer (Pos.10) you can set up your favorite value. This value is shown on
the left display. The unit [sec] is shown by the LED at the left display.
4. By pressing the button „Set" (Pos.07) you can choose the gas post flow.
With the potentiometer (Pos.10) you can set up your favorite value. This value is shown on
the left display. The unit [sec] is shown by the LED at the left display.
Four seconds after the last setting changes the device always returns to the standard
settings!
Other functions:
1. By pressing the button "gas test" (Pos.08) you can choose the appropriate gas-rate.
2. By pressing the button „wire feed" (Pos.09) the welding wire will be inserted
through the feed mechanism and through the welding torch.
The welding device is ready for welding now!
58
CPTX 400-2/400-2w/450-2w Synergy