Fronius String Control 250/25 Dcd Df Installation; Dowels And Screws; Installation Position; Selecting A Location - Fronius String Control 250/25 DCD DF Bedienungsanleitung

Fronius String Control 250/25 DCD DF Installati-
on
Dowels and Depending on the surface, different dowels and screws may be required
Screws for installing the Fronius String Control 250/25 DCD DF. Therefore, these
dowels and screws are not part of the scope of supply for the Fronius
String Control 250/25 DCD DF. The installer is responsible for selecting
the proper dowels and screws.
Installation The Fronius String Control 250/25 DCD DF can be installed in any positi-
Position on from horizontal to vertical. The cable inputs and outputs should point
downwards.
Selecting a
When selecting the location, please observe the following criteria:
Location
-
-
-
-
-
Install only on a solid and level surface; the housing must not warp
when it is fastened with the screws.
The ambient temperature may not fall below -25 °C nor exceed +55 °C.
Protection type IP 55 means that the Fronius String Control 250/25
DCD DF can be installed outside and be exposed to a certain amount
of moisture. However, we do recommend that direct wetting be avoi-
ded.
Protect from direct sunlight and direct exposure to the elements.
Install under the solar modules where possible.
10