Inhaltsverzeichnis
Werbung
4.4 MU5 Native Parameter Change
11110000 F0
01000011 43
0001nnnn 1N
00101011 44
0aaaaaaa aaaaaaa
0aaaaaaa aaaaaaa
0aaaaaaa aaaaaaa
0ddddddd ddddddd
|
|
0ccccccc ccccccc
11110111 F7
The sending device must send a separate header (address setting) for each individual
parameter. For example, System parameters and Multi Part parameters are not
continuous, and so they must be separated, with each header added individually. The
following parameters must be separated into individual packets:
• System
• Multi Part
• Reset All Parameters
After adding the Start Address, Data and Checksum, the checksum's first 7 bit
values will be 0.
If the received data is outside the "legal" range (i.e., higher or lower than the
maximum and minimum set values at each address), the MU5 changes the value to
the nearest maximum or minimum setting.
4.4.1 System Data Parameter Change
Refer to charts 1-1 and 1-2 on pages add-21 and add-22.
4.4.2 Multi Part Data Parameter Change
Refer to charts 1-1 and 1-3 on pages add-21 and add-22.
4.4.3 System Information
Upon reception of a Dump Request, the MU5 transmits the relevant data, but
ignores all other incoming messages during transmission.
Refer to charts 1-1 and 1-4 on pages add-21 and add-23.
= Exclusive status
= YAMAHA ID
= Device number
= MU5 Model ID
= Start address 1st byte
= Start address 2nd byte
= Start address 3rd byte
= Data
|
|
= Checksum
= End of exclusive
MIDI Data Format
add-
17
Werbung
Inhaltsverzeichnis
