Operation - Geemarc AMPLICALL16 Bedienungsanleitung

INSTALLATION
Note: Do not use a rechargeable battery. Do not put the
used battery into the household rubbish, pay attention to
battery regulations regarding battery disposal.
Volume Control Slide Switch
The volume control slide switch can be used to set the
volume of the alarm sound and switch the power on/off.
The Pairing Procedure:
The supplied door bell has been paired with the base,
there is no need to pair them. If the door bell is not
paired with the base or you wish to pair the base with
another door bell, please follow the pairing procedure
below.
Press and hold the Pairing/Test button of the unit whilst
pressing the doorbell button until the strobe flasher LED
starts to flash. The unit will make a beep sound to confirm
that pairing has taken place successfully.
To check whether the device is working properly and has
been paired correctly, press the pairing/testing button
once. The device should sound the alarm and flash.

Operation

Once the Amplicall 16 and the Door bell have been
placed in the required locations and all required batteries
have been inserted, you are ready to use the device.
To use the device, the person who needs assistance
must press the door bell button of the door bell.
5