Hama Color EWS-1200 Bedienungsanleitung Seite 8

Note – Time settings
• The search process takes about 3-10 minutes.
If the search fails, it ends and is repeated at
the next clock hour. The wireless symbol (6)
will go out.
• In the meantime you can, however, set the
time and the date manually.
• The clock automatically continues to search
for the DCF signal on a daily basis (between
02:03 a.m. and 03:03 a.m.). If the signal is
received successfully, the manually-set time
and date are overwritten.
• Press and hold the
approx. 3 seconds to stop the manual search.
Note – Summer time
The clock automatically switches to summer time.
DST appears on the display as long as summer
time is activated.
Note – restricted function
The display auto-scroll function and the infra-red
motion sensor are temporarily disabled while the
radio-controlled clock is receiving the time signal,
and re-enabled after reception is complete.
(Manual) settings
• Press and hold the MODE / SET button (11) for
approx. 3 seconds to make the following settings
one after the other:
• 12/24 hour format (3)
• Time zone (3)
• Hours (3)
• Minutes (3)
+ button (12) again for
• Year (3)
• D/M – M/D (3) display
• Month (3)
• Day (3)
• Symbol for current weather forecast (2),
• Temperature units °C/°F (7)
• Motion detector on/off
• Permanent backlight on/off
• To select the individual values, press the
+button (12) or the AUTO – button (13) and
confirm each selection by pressing the MODE /
SET button (11).
• Press the MODE / SET button (11) immediately to
adopt the set value displayed and to skip onwards.
• If you do not make an entry for 60 seconds, you
automatically exit setup mode.
Note – Time zone
• The DCF signal can be received over long
distances, but always transmits the current
Central European Time in Germany. Make
sure you account for the time difference in
countries with another time zone.
• If you are in Moscow, the time is 3 hours
later than in Germany. This means that you
should set +3 for the time zone. The clock
then automatically sets the time to 3 hours
after the DCF signal received or relative to the
manually set time.
• To use no time zone, set the time zone to 0.
Alarm
• Press the ALARM button (9) to display the
alarm time.
• Press and hold the ALARM button (9) to call up
alarm set mode.
• To set the desired hour and minute, press the
button (12) or the AUTO – button (13). Press the
ALARM button (9) to confirm the setting.
+
7