Operating Elements & Connections - Omnitronic PAS PRO DSP Bedienungsanleitung

4
OPERATING ELEMENTS & CONNECTIONS
1 POWER indicator
2 SIGNAL indicator
3 LMT indicator
Lights when the signal level is too high; the
limiter will reduce the signal level to protect the
speakers.
4 DSP PRESET switch with LEDs
To select various equalizer presets according
to your application:
FLAT = frequency response is not affected,
LIVE 1 = high frequency attenuation,
LIVE 2 = low and high frequency boost,
DJ 1 = loudness function,
DJ 2 = increased loudness function
5 Line input LINE A
Balanced combo input (XLR/6.3 mm jack) and
unbalanced RCA L/R input for connecting
audio units with line level (e.g. mixer, CD
player). Always use one of the inputs at a
time.
6 Volume control for the line input
7 Output MIX OUT
Balanced XLR output of the master signal of
both channels for connection to a line input of
a mixer, amplifier or a further active speaker.
8 Microphone/line input MIC/LINE B
Balanced combo input (XLR/6.3 mm jack) for
connecting a microphone or a further audio
unit with line level.
9 Volume control for the microphone input
10 Input selector switch LINE/MIC
Switches input MIC/LINE B between line and
microphone input.
• switch disengaged = line input
• switch engaged = microphone input
11 Power input
Used to plug in the supplied power cord.
12 Fuse
Only replace the fuse when the device is
disconnected from mains. Only use fuses of
the same rating and power. The correct fuse
value is specified on the rear panel.
13 Power switch
Turns power to the speaker system on and off.
20