Klarstein 10030014 Bedienungsanleitung Seite 13

Selector Display
Switching display temperatures in Celsius or Fahrenheit. To choose one of these displays press the button
for 5 seconds.
Select the Temperature
Your wine cellar has one single compartment. The temperature can be chosen between 5-22 °C (40-72 °F).
Before switching on
• Make sure that it has been installed by a suitably qualified person, as per the information contained in the
installation instructions.
• After delivery, wait for 24 hours before connecting the appliance to your mains supply. This will allow any
refrigerant gasses that may have been disturbed during the transportation process to settle.
• The outside of the appliance and the removable accessories contained within it, should be cleaned with a
solution of liquid detergent and water.
• The interior of the appliance should be cleaned with a solution of sodium bicarbonate dissolved in lukewarm
water. The interior and accessories should be thoroughly dried, after the cleaning process has been completed.
• There can be an odour when you first switch on the appliance. It will lessen as the appliance starts to cool.
During first use
IMPORTANT: When you use the wine cooler for the first time or restart the appliance after it has been turned
off for a long time, there could be a few degrees variance between the temperature you select and the one
indicated on the LED display. This is normal and it is due to the length of activation time. Once the wine
cooler has been running for a few hours everything will be back to normal.
• When you first switch on the appliance, the compressor will run continuously until the wine cooler reaches
a cool enough temperature.
• During this period of time, you should try not to open the door frequently or place bottles inside of the appliance.
• If the unit is switched off or unplugged, you must allow at least 5 minutes before restarting the appliance or
reconnecting it to your mains supply.
Switching on the appliance and setting the temperature
• To switch the appliance on, press the Power button and hold 5 seconds, turn the appliance off again, press
and hold the Power button for 5 seconds.
• When you press the TEMPERATURE SET BUTTONS [+] or [-] for the first time, the LED display will indicate
the factory preset temperature.
• Press the TEMPERATURE SET BUTTONS [+] or [-] once. The display will increase or descrease 1°C or 1°F
until the temperature you want.
• To see the set temperature at any time, touch the buttons UP BUTTON [+] or DOWN BOTTON [-] set
temperatures temporarily flash on the display for about 5 seconds.
IMPORTANT: When the temperature is changed, the compressor works harder to reach the required tem-
perature. And the compressor will work slowly and even stop working when the set temperature is reached.
13