Hama Color Edge Bedienungsanleitung Seite 6

5.2 Measuring station
• You can also position the measuring station on a level outdoor surface.
• We recommend installing the measuring station securely on an outdoor wall using the recess (27).
• Install an anchor, screw, nail, etc. in the wall of your choice.
• Hang up the base/measuring station using the opening (27) intended for this purpose.
6. Operation
6.1 Connection to the measuring station
• When the batteries have been inserted, the base station automatically searches for a connection to
the measuring station and to the radio signal.
Note
• The respective symbols will flash during the connection attempts:
measuring station,
• Do not press any buttons during setup. Otherwise, values may not be transmitted correctly and
there is a risk of value errors and inaccuracies.
• Do not change the location of the base station during the search processes.
• The process is completed when the indoor (8) and outdoor (3) measurement data is displayed.
6.2 Basic and manual settings
Automatic setting using the DCF signal
When the base station has been switched on for the first time and successful transmission has been
established between the base station and the measuring station, the clock will automatically search for
the DCF signal. During the search, the radio symbol
Flashing display
Manual entry not possible!
Constant display
• If the station still does not receive a signal, press and hold the UP button (19) for approximately 3
seconds to start the manual search for the DCF signal. The radio symbol
Note – Time settings
• The search process can take up to 7 minutes. If it fails, the radio symbol
• In the meantime, however, you can set the time and the date manually.
• The clock automatically continues to search for the DCF signal on a daily basis (at 1 am and 5
am). If the signal is received successfully, the manually set time and date are overwritten.
Note – Summer time
The clock automatically switches to summer time.
time is activated.
connection to the DCF signal
Display
No display
connection to the
flashes.
Search for the DCF signal
Active
Successful –
signal is being received
Inactive
appears on the display as long as summer
starts to flash.
will go out.
5