Maintenance - Makita 6835D Betriebsanleitung

Driving in corner (Fig. 13)
This tool can be used to drive at a position 15 mm
away from the wall as shown in Fig. 13.
CAUTION:
Driving at a position closer than 15 mm to the wall or
driving with the stopper base in contact with the wall
may damage the screw heads and cause wear on the
bit. This may also lead to poor fastening of screws
and malfunction of the tool.
Installing or removing bit (Fig. 14 & 15)
Important:
Always be sure that the tool is switched off and the
battery cartridge is removed before installing or
removing the bit.
Loosen the thumb screws which secure the casing.
Pull out the casing in the direction of the arrow. Press
the dust cover toward the plain bearing and pull out
the bit. If the dust cover cannot be moved as far as the
plain bearing, try it again after turning the bit slightly.
To install the bit, insert it into the socket while turning
it slightly. After installing, always make sure that the
bit is securely held in place by trying to pull it out.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out any
work on the tool.
To maintain product safety and reliability, repairs,
maintenance or adjustment should be carried out by a
Makita Authorized Service Center.
7