Cleaning The Spray Arms; Internal Cleaning; External Cleaning; Troubleshooting - Electrolux GA60SLVSCN Benutzerinformation

11.2 Cleaning the spray arms

Do not remove the spray arms. If the holes
in the spray arms are clogged, remove
remaining parts of soil with a thin pointed
object.

11.3 External cleaning

• Clean the appliance with a moist soft
cloth.
• Only use neutral detergents.
• Do not use abrasive products, abrasive
cleaning pads or solvents.

12. TROUBLESHOOTING

If the appliance does not start or it stops
during operation. Before you contact an
Authorised Service Centre, check if you
can solve the problem by yourself with the
help of the information in the table.
Problem
You cannot activate the appli-
ance.
The programme does not start.
The appliance does not fill with
water.
The display shows the mes-
sage: Attention: no intake of
water possible.
The appliance does not drain
the water.
The display shows the mes-
sage: Attention: water is not
draining.

11.4 Internal cleaning

• Carefully clean the appliance, including
the rubber gasket of the door, with a
soft moist cloth.
• If you regularly use short duration
programmes, these can leave deposits
of grease and limescale inside the
appliance. To prevent this, we
recommend to run long duration
programmes at least 2 times per
month.
With some problems, the display
shows a message.
Possible solution
• Make sure that the mains plug is connected to the
mains socket.
• Make sure that there is no a damage fuse in the
fuse box.
• Make sure that the appliance door is closed.
• If the delay start is set, cancel the setting or wait
for the end of the countdown.
• The appliance has started the procedure to re-
charge the resin inside the water softener. The du-
ration of the procedure is approximately 5 mi-
nutes.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is
not too low. For this information, contact your lo-
cal water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not
clogged.
• Make sure that the inlet hose has no kinks or
bends.
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or
bends.
ENGLISH 19