Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
This situation can occur if:
- the XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective,
- the cable or connector is defective or the signal wires are swap in the input connector.
DMX-protocol
Channel:
1
PAN Rotation
2
TILT Rotation
3
Speed
4
Master Dimmer
5
Strobe
6
Red
7
Green
8
Blue
9
Programs
CLEANING AND MAINTENANCE
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.
Replacing the fuse
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse-holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse-holder.
Step 3: Install the new fuse in the fuse-holder.
Step 4: Replace the fuse-holder in the housing.
Value:
Function:
000 – 255
Set position from 0 – 330°
000 – 255
Set position from 0 – 220°
000 – 255
Decreasing speed
000 – 255
Increasing brightness
000 – 000
No function
001 – 255
With increasing speed
000 – 255
Increasing brightness
000 – 255
Increasing brightness
000 – 255
Increasing brightness
000 - 127
No function
128 - 209
AU01 (Auto program fast)
210 - 249
AU02 + SNON (Auto program slow + sound control)
250 - 255
Reset
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
21/24
00107158, Version 1.0
Werbung
Inhaltsverzeichnis
