Setup; Attachment; Dmx512 Control - EuroLite LED TMH-48 Bedienungsanleitung

SETUP

Attachment

The lighting effect can be fastened to a wall or ceiling with four screws via the holes in the base plate.
Always choose screws and plugs which are suitable for use in your wall/ceiling and have enough holding
power. Fasten the device in such way that it will not fall down.

DMX512 control

The wires must not come into contact with each other, otherwise
Please note, the starting address depends upon which controller is being used.
Device 3
Starting address 19
DMX IN DMX OUT
1: Ground
2: Signal (–)
3: Signal (+)
120 Ohms
Only use a DMX cable and 3-pin XLR plugs and connectors in order to connect the controller with the fixture
or one fixture with another.
Occupation of the XLR connection:
If you are using controllers with this occupation, you can connect the DMX output of the controller directly
with the DMX input of the first device in the DMX chain. If you wish to connect DMX controllers with other
XLR outputs, you need to use adapter cables.
Building a serial DMX chain:
Connect the DMX output of the first device in the DMX chain with the DMX input of the next device. Always
connect one output with the input of the next device until all devices are connected.
Caution: At the last fixture, the DMX cable has to be terminated. Plug the terminator with a 120
between Signal (–) and Signal (+) in the DMX output of the last fixture.
the devices will not work at all, or will not work properly.
Device 2
Starting address 10
DMX IN DMX OUT
1: Ground
2: Signal (–)
3: Signal (+)
18/24
Device 1
Starting address 1
DMX IN DMX OUT
1: Ground
2: Signal (–)
3: Signal (+)
DMX-512 Controller
00107158, Version 1.0
Ω resistor