Initial Use; Installation Location - Beurer LB 44 Gebrauchsanweisung

1. Mist outlet
2. Recessed grip
3. Water tank
4. Water tank screwed plug
5. Water basin
6. Base unit for air humidifier
7. Fill level sensor
8. Ultrasound membrane
9. Control dial
10. LED display
11. Mains cable
12. Aroma compartment
Principle behind the LB 44 air humidifier
1 High-frequency vibrations release tiny drops from the surface of the water.
2 The fan air flow transports the humid air out into the room.
3 Water evaporation can also be switched on.
4 If you wish, the device can be used with aromas.

5. Initial use

Unpacking the device
WARNING
Keep packaging material away from children! There is a choking hazard.
• Open the cardboard packaging.
• Remove the protective insert.
• Keep the plastic film closed.
• Lift the device up and out of the packaging.
• Remove the plastic covering.
• Check the device, the mains plug and the cable for damage.

Installation location

WARNING
Before putting the device into operation, read the safety notes in the Safety chapter.
Note
• The immediate vicinity of the air humidifier can become damp.
• Calcareous water can leave white deposits.
• Do not place the device on the floor, but in a raised position (e.g. on a table or chest of drawers).
• Position the device so that the mist outlet is not directed towards objects.
• Empty any remaining water when the device is not in use.
• Place the air humidifier on a firm, level and water-resistant surface.
If the device should accidentally tip over, water may escape, even if the device is switched off and un-
plugged.
14
12