Manual Code Search; Learning Codes - Ebode TAKE 6 IR Bedienungsanleitung

4.4 Manual code search

Note: as you can dedicate any appliance TV, DVR, DVD,
STB, AUDIO, AUX, keys, you first need to enter any 4-digit
code for the kind of appliance you wish to control (found
in the code book), i.e.: If you want to program a STB
under the AUX key, enter ANY STB code found in the
code book and then follow the steps below:
1. Make sure your equipment is switched on.
2. Press and hold S (8) until the LED indicator lights
steadily. Release S
3. Press the mode key (4) that matches the equipment
you want to control (for example TV).
4. Press CHAN+ (6) repeatedly until the channel changes.
If you step past the correct code use CHAN- (6) to go
back to the right code.
5. When the equipment you want to control reacts, press
-/-- (13) to confirm the code.
Note: If your equipment doesn't have CHAN+ you can
use PLAY (DVR or DVD) (15) or POWER (1) key. The search
starts after the last registered code. If that was 030, the
search starts at 031 until the last possible code and then
goes from 000 to 029. Note: if certain functions of your
equipment can't be controlled you will have to find a
different code for your brand.

4.5 Learning codes

Your TAKE 6 Remote contains the codes for most TVs, videos
etc. in its code library. If a certain device is not in this library,
you can learn the codes for your existing remote control.
The library may also contain a code that works for your
device, but which misses a few function buttons. You can
then select to only learn those buttons (maximum of 150
buttons).
Master clear
You can use the MASTER CLEAR method to clear the
learning memory. It is advised to execute a MASTER CLEAR
before you start learning any commands.
1. Keep the SETUP (8) pressed until the LED stays lit. Release
the SETUP (8) button.
2. Press the LEARN (20) button twice. The LED will flash every
time you press the button.
3. Press SETUP (8). The LED will extinguish after a few
seconds.
Notes:
• Execute a Master Clear before you start learning (see the
method above).
• Make sure both remote controls have full batteries before
you start learning codes.
• Make sure you do not move the remote controls when
pressing the buttons.
• You cannot learn any commands for the following
buttons: Learn, Setup, Guide, Source buttons TV, VCR, CBL,
etc, Home Control.
• Experiment by learning two or three buttons first (to test
compatibility), before you learn all the buttons of your
original remote control.
• When the memory is full, the LED will flash for 3 seconds.
You cannot learn any codes when the memory is full. You
can, however, erase a mode with codes you stored. You
can only erase a full mode.
23-5-2012 9 ebode TAKE6 IR