Ebode TAKE 6 IR Bedienungsanleitung Seite 12

-Switch on the lights at night to frighten intruders when
you detect something suspicious.
-Switch on your electric blanket before the film ends to
have it warm when you go to sleep.
For controlling your lamps or appliances, you will need an
IR7243RF and additional ebode / X10 home modules. The
modules are simply plugged into a/c outlet with no
additional wiring required.
Contact your retailer for additional information.
5. Troubleshooting
The remote doesn't work or loses codes entered
• Confirm with your original remote that the equipment
works correctly.
• Make sure that you have pressed the corresponding
mode key of the equipment or device that you want to
control.
• If the listed code does not work, try the AUTOSEARCH
method or enter the next code of that brand.
• Check that the batteries have the correct polarity
position.
• The programming of the remote requires 2 AAA
batteries (new).
• If the LED is lit permanently, in general it will be
necessary to replace the batteries.
• Set the remote back to factory default.
How to set the TAKE 6 Remote back to factory default
• Press and hold S (8) until the LED indicator (2) lights
steadily. Release S.
• Press and hold S (8) until the LED indicator (2) lights
steadily. Release S.
• Press and release the 0 key (14) once.
• Press and release the S key (8).
• The LED (2) turns off after few seconds.
23-5-2012 12 ebode TAKE6 IR