Identifying Codes Found - Ebode TAKE 6 IR Bedienungsanleitung

• By keeping the buttons for the existing remote control
pressed for a shorter period, there will be more memory
space left for learning codes on the TAKE 6 remote control.
This also diminishes the chance that the remote control
learns the wrong codes.
• Experiment with the distance between the remote
controls if you have problems learning the codes.
• Some remote controls do not have the infrared LED in the
centre. Try experimenting by slightly moving the remote
controls (sideways or up/down). Tube lighting and bright
sunlight can affect the procedure.
• You can only learn the codes for one original remote
control per mode, e.g. the codes for your DVD remote
control under the DVD button. With some combi devices
(e.g. a TV with built-in DVD player) you first have to learn
the TV functions in TV mode and then the DVD functions in
DVD mode.
Learning the commands
1. Point your existing remote control at the TAKE 6 Remote
(front to front). Keep a distance of 2,5 cm between the
remote controls.
2. Press the SETUP (8) button until the LED stays lit. Release
the SETUP (8) button.
3. Press the Mode button (TV, AUDIO, SAT, etc.) for the
device you want to learn. The LED will flash once.
4. Press the LEARN (20) button. The LED will flash once.
5. Press the button on the TAKE 6 remote you want to store
the new command under. The LED will blink once.
6. Depending on the type of remote control you have, you
can use one of two methods:
a. Press the button on the existing remote control you want
to learn. Keep this button pressed until the LED on the TAKE
6 Remote extinguishes. If the LED does not extinguish, but
starts flashing, you need to use method B. (If youhave just
tried method A and want to try method B, first repeat step
5).
b. Press the button on the existing remote control you want
to learn. Keep this button pressed as long as you would
when using the original remote control.
7. Repeat steps 5 and 6 for every button you want to learn.
8. When you have finished learning the buttons, press SETUP
(8)
Erasing the commands learned per mode to clear memory
space
You can erase the commands learned and saved for each
separate function (TV, VCR, etc.):
1. Keep the SETUP (8) button pressed until the LED stays lit.
Release the SETUP (8) button.
2. Press the Mode button of your choice (TV, DVR, etc.). The
LED will flash once.
3. Press the LEARN (20) button twice.
4. Press SETUP (8). The LED will extinguish after a few
seconds.
5. All commands learned and saved for the selected
function have now been erased.

4.6 Identifying codes found

If you don't know the code (for example because you
found the code by autosearch) you can identify it as
described below:
23-5-2012 10 ebode TAKE6 IR