Programming; Manual Code Entry; Automatic Code Search For Some Well-Known Brands - Ebode TAKE 6 IR Bedienungsanleitung

Programming button for learning the functions of your
original remote control. See chapter 4.5, Learning codes,
for information about programming these codes.
[21] Teletext
Teletext ON: Start/stop Teletext / Fasttext.

4. Programming

To make your remote suitable for your own equipment,
you have to program it once. You can do this by entering
a code, related to the brand and type of equipment you
want to control. You can program any equipment under
any MODE key. For example, if you have three
videorecorders, you can program videorecorder 1 under
DVR, videorecorder 2 under AUX and videorecorder 3
under AUDIO.

4.1. Manual code entry

Take your code book and search for the list matching the
equipment you are looking for, e.g. TV or DVR. Next, find
the relevant brand (e.g. Sony). Now you will find one or
more 4-digit codes. If there is more than one code, it
depends on your equipment which code is correct.
Generally, the codes are displayed in order of age of the
equipment. Older equipment first, younger equipment at
the end. Sometimes you will have to try several codes
before you find the right code for your equipment.
1. Make sure your equipment is switched on (for example
TV).
2. Press and hold the S (8) key until the LED indicator lights
continuously. Release the S key.
3. Press and release the mode key (4) of the device you
want to control (for example TV).
4. Enter the 4-digit code from the Code Book by using the
key pad (14). The LED (2) turns off after the last digit is
entered. If you entered a wrong code the LED blinks for 3
seconds and then goes off. You have to repeat from step
2.
5. Point the remote in the direction of your TV and press
the POWER button (1). Your device should turn off. Check
other functions (for example for a DVR FF or REW, etc.). If
certain functions are not responding, this indicates that
the entered code is not the correct one. In that case
repeat the above procedure with the next
corresponding code of your brand.
6. Repeat this procedure from step 1 for the other
equipment you want to control (DVR, DVD, STB,...). If your
equipment (TV, STB, etc....) does not respond, try the
other codes for your brand. If it still doesn't respond, try
the manual code search method (4.4 Manual code
search).

4.2. Automatic code search for some well-known brands

If your brand is listed hereafter, you can use the brand
search method (faster than the "manual" and the
"automatic code search").
23-5-2012 7 ebode TAKE6 IR