Quick Start Guide; Introduction - Ebode TAKE 6 IR Bedienungsanleitung

Quick start guide

1) Put the batteries in
1. Open the cover on the back of the 6 in 1 Universal
Remote Control
2. Insert the two AAA batteries. Make sure the batteries
are NEW.
2) Program your 6 in 1 Universal Remote Control
1. Turn on the equipment that you wish to control ( TV,
DVR, DVD, STB, AUX, AUDIO).
2. The AUX key allows you to program and control any
equipment such as TV, DVR, DVD, CD, STB.
3. Take the code book supplied with the 6 in 1 Universal
Remote Control and find the brand of the equipment
you wish to control. E.g. if you have a Thomson TV look
for Thomson under the TV section.
4. Press and hold on the key marked "S" (8) until the LED
(2) stays permanently on. This takes about 3 seconds.
Release the "S key".
5. Press and release the TV, DVR, DVD, STB, AUX, AUDIO,
mode key (4), in accordance with the appliance you
wish to control.
6. From the code book take the first number
corresponding to your equipment and enter the number
by pressing the 0-9 key pad (14). Each time you press a
key the LED (2) will flash.
7. If the number is correctly entered the LED will turn off. If
the number is incorrect then the red LED will flash fast. If
incorrect you will need to restart at 4.
Press the POWER key (1) . If your equipment switches off
you have found the right code. If it does not switch off,
you will need to restart from 4.
Sometimes there are several codes that have similar
features. If you find that your 6 in 1 Universal Remote
Control does not work for some functions, you may need
to try another code.

1. Introduction

The TAKE 6 is designed to control up to 6 devices:
TV, DVR, DVD, STB, AUDIO or any other device under AUX
mode key. The TAKE 6 contains a library of codes that are
preprogrammed into the remote control. This library
covers nearly all the audio video products on the market
today. The codes have to be programmed once before
use. This can be done in different ways:
23-5-2012 4 ebode TAKE6 IR