Installation - Pioneer S-FL1 Bedienungsanleitung

Installation

No stand or other fittings for mounting the speaker are
supplied. Please use appropriate fittings, screws, etc. in
order to install the speaker properly.
You will need a cross-head screwdriver or hexagonal
wrench for installation.
Note
• Please use screws suitable for the wall material and
strength. The following is a guide to the length of
screws you should use for the speaker and fittings:
Depth of mounting material +
washer + 7~15 mm
• Do not overtighten the screws as this can cause
damage.
• To reduce the risk of the speaker falling or toppling
over should there be an accident, please reinforce
the mounting fittings for added safety.
Installation example 1 (horizontal
mounting)
1 Use the two screw holes on the longer side of the
speaker.
150 mm
2
or other fitting to the speaker.
Installation example 2 (vertical mounting)
1
the speaker.
Screw holes
(M8 x P1.25)
16.5
5
19
Unit : mm
Use two screws with washers to attach the stand
Use the two screw holes on the shorter side of
150 mm
Screw holes
(M8 x P1.25)
Washer
Screw
3
En