Connecting To Your Amplifier - Pioneer S-FL1 Bedienungsanleitung

2 Use two screws with washers to attach the stand
or other fitting to the speaker.
Please take extra care in selecting a location for upright
installation as the speaker is less stable.
Intallation example 3 (other)
1 You can also use the screw holes on the rear of
the speaker for installation. Remove the caps to use.
You'll need a 5 mm hexagonal wrench for the screws that
keep the caps in place.
Please keep the caps in a safe place in case you need to
use them again.
4
En
Washers
Screws

Connecting to your amplifier

Caution
• Be careful not to short the two pins (1+ and 1–) of the
free speaker terminal. Doing so could damage the
speaker and/or your amplifier.
• Switch off the amplifier before connecting any
speakers.
There are two connection terminals on the rear side of
the speaker. To connect the speaker to your amplifier you
will need a suitable speaker cord terminated in a Neutrik
®
Speakon speaker connector [NL4MP]. Only the 1+ and
1– pins should be connected. These connect to the
positive (+) and negative (–) speaker terminals
respectively on the amplifier.
Neutrik [NL4FX] and [NL4FC] Speakon speaker cord can
be used for the connection. Please refer to Neutrik for
more information.
1 Use a suitable speaker cord (not supplied) to
connect the speaker terminal on your amplifier to
one of the input terminals on the rear of the
speaker.
The speaker's terminals are exactly the same; use
whichever is convenient.
• See the manual that came with your amplifier for
more details.
a Plug the speaker cord connector into the
speaker's input terminal. Check the alignment for
the connector with the jack before plugging in.