Final Assembly; Control Throws - Tomahawk CYCLONE Handbuch

ENGLISH
Apply some epoxy to the socket of the multi-
lock and install the pin in the socket. Assem-
ble the wing on the fuselage and let the ep-
oxy cure. Use the same process on the outer
wings.
Your model is nearly finished. Additional to the Multilock it is mandatory to use tape as well to
secure all wing parts together and the wings to the fuselage. The needed electronics are to be
mounted and the transmitter programmed. Find the control throws and the CG below in the table.
We are suggesting to use 3 flight modes (Standard, Speed, Thermal) as well as a Butterfly brake.
Ailerons
Elevator
Rudder
Flaps
110 bis 120 mm back from the leading edge of the wing and against the fuselage.
32
47

FINAL ASSEMBLY

CONTROL THROWS

Normal Thermal
▲ 30 mm
▼ 18 mm
▲ 20 mm
▼ 12 mm
◄ 60 mm
► 60 mm
▼ 5 mm
CENTER OF GRAVITY
ASSEMBLY THE MOTOR
48
Install the motor and use threadlock.
Speed
▲ 3 mm
Butterfly
▲ 25 mm
▼ 8 mm
▼ 55 mm