Tomahawk CYCLONE Handbuch Seite 21

06
Fix the aileron with tape to neutral and mark
the position of the rudder horn.
08
Install the linkage in the second hole of the
servo horn. Enlarge the hole if needed. Con-
nect the clevis to the rudder horn. Adjust
the clevis so the aileron is centered when
the servo is centered using the radio system.
Tighten the nut against the clevis and use
some threadlock.
07
Make a slot for tue rudder horn and glue it in
with epoxy.
09
Use hobby scissors to trim the aileron servo
cover. Don't use the markings as these will
not fit. You have to measure the correct di-
mension. The cover is attached to the wing
using clear tape or thin CA.
ENGLISH
21