Programming And Memorizing Chases; Inserting A Scene Into A Chase - EuroLite DMX MOVE CONTROL 512 Bedienungsanleitung

Programming and Memorizing Chases

For programming chases (sequences of scenes),
32 memory banks are available. A sequence of up
to 100 steps can be programmed on each
memory bank. Previously memorized scenes may
also be compiled to a chase in any desired order.
Chases may run automatically, manually, or
sound-controlled.
Program
Fig. 7.8 Programming mode
1
Call the programming mode. For this, keep
the REC pressed until the LED above the
button lights.
2
Press the button CHASE.
• The control LED lights.
Program
Chase01 Step001
Fig. 7.9 Programming a chase
3
Select the desired memory bank with one of
the number buttons 1-16.
• If necessary, use the button PAGE to switch
between the two channel groups 1-16 (LED
A lights) and 17-32 (LED B lights).
• The display indicates e.g. "Chase01
Step001" in the lower line.
4
Press the button FIXTURE.
• The control LED lights.
5
Use the number buttons 1-16 to select the
devices to be controlled.
• If necessary, use the button PAGE to switch
between the two channel groups 1-16 and
17-32.
Program
CH:02 Val:098
Fig. 7.10 Adjusting the first scene
6
Adjust the first illumination scene with the
sliding controls and, if necessary the pan and
tilt wheels.
• The display indicates the number of the
control channel in the lower line and the
current output value as a DMX value.
7
It is also possible to call a scene previously
memorized or a movement pattern or color
effect and to insert it into the chase. For this,
call the scene or the effect with the button
SCENE or MOVEMENT and the
corresponding number button.
8
Press the button REC to memorize the
scene.
• To confirm the memory procedure, all LEDs
of the controller flash three times.
• The indication "Step001" changes to
"Step002" and you can adjust and memorize
the next scene.
9
Repeat the steps 6 to 8 to adjust and
memorize the next scene.
• Up to 100 scenes can be programmed for a
chase.
10
After the desired chase has been
memorized, switch off the programming
mode. For this, keep the button ENTER
pressed until the display indication switches
back to "Manual".

Inserting a Scene Into a Chase

1
Call the programming mode. For this, keep
the REC pressed until the LED above the
button lights.
2
Press the button CHASE.
• The control LED lights.
3
Select the chase to be extended with one of
the number buttons 1-16.
• The control LED of the number button lights
and the display indicates the number and
steps of the chase.
• If necessary, use the button PAGE to switch
between the two channel groups 1-16 (LED
A lights) and 17-32 (LED B lights).
4
Select the step after which a new step is to
be inserted with the pan wheel.
5
Press the button MENU.
• The LED INSERT above the button lights.
6
Now, a scene can be inserted. For this, call
the scene with the button SCENE and the
corresponding number button.
7
Press the button REC to memorize the
revised chase.
• To confirm the memory procedure, all LEDs
of the controller flash three times.
8
Repeat the steps 4 to 7 to insert further
scenes into this chase.
9
After the revised chase has been
memorized, switch off the programming
mode. For this, keep the button ENTER
pressed until the display indication switches
back to "Manual".
34/40 00081469.DOCX, Version 1.0