EuroLite DMX MOVE CONTROL 512 Bedienungsanleitung Seite 26

1 Sliding controls 1 to 16
• For adjusting the DMX values of the
connected light effect units. The current DMX
value is indicated in the display.
• Controls 1-4 adjust the brightness ratio of the
red, green, blue and white LEDs of the light
effect units and control 5 adjusts the total
brightness.
2 Number buttons 1 to 16 with LEDs
These buttons control different functions
depending on the selected mode and have a
dual occupancy; the button PAGE allows to
switch between the two channel groups 1-16
and 17-32.
• FIXTURE: To select and deselect devices.
• MOVEMENT: To activate and deactivate
movement patterns (button 1-9) or color
effects (button 10-16).
• SCENE: To activate or deactivate illumination
scenes.
• CHASE: To activate or deactivate chases.
3 Button PAGE with LEDs
To switch the number buttons between the
two channel groups 1-16 and 17-32.
• LED A lights: channel group 1-16 is selected.
• LED B lights: channel group 17-32 is
selected.
4 Button FIXTURE with LED
• With the button actuated (LED lights) the
number buttons allow to select and deselect
devices.
• For adjusting the fade in time for the RGBW
color channels together with the pan wheel.
5 Button MOVEMENT with LED
With the button actuated (LED lights) the
number buttons allow to activate and
deactivate movement patterns or color effects.
6 Button SCENE with LED
With the button actuated (LED lights) the
number buttons allow to activate and
deactivate illumination scenes.
7 Button CHASE with LED
With the button actuated (LED lights) the
number buttons allow to activate and
deactivate chases.
8 Data wheel PAN
For controlling the pan movement of moving
heads or scanners and for programming
functions.
9 Data wheel TILT
For controlling the tilt movement of moving
heads or scanners and for programming
functions.
10 USB port
For connecting a USB storage device for
storing and importing data and firmware
updates.
11 Button REC/ENTER with LED
• Long actuation: To activate or deactivate the
programming mode.
• Short actuation: For storing individual
illumination scenes or chases and for
confirming adjustments.
12 Button MENU/ESC with LED
• Long actuation: To call and exit the system
settings.
• Short actuation: To abort a setting procedure
and jumping back to a higher menu level.
13 Button BLACK OUT/DEL with LED
• Sets all control channels to the value zero
(e.g. for turning off the devices).
• For deleting illumination scenes or chases.
• For inserting a scene into a chase.
14 Button RUN MODE/SWAP with LEDs
• For setting the running mode of a chase. A
short actuation switches between manual,
sound-controlled and automatic mode. The
LEDs next to the button indicate the current
setting.
- MANUAL: The chase can be manually
advanced step by step with the pan wheel.
- MUSIC: The individual steps of the chase run
to the rhythm of the music picked up via the
internal microphone.
- AUTO: The individual steps of the chase run
at the adjusted speed and fade time.
• For switching between the parameters when
editing movement patterns.
15 Display
16 DMX512 output
3-pin XLR jack for connecting the DMX input
of the first light effect unit.
17 Power input
Plug in the mains cable of the supplied power
unit here.
18 Power on/off
Switches the controller on and off.
26/40 00081469.DOCX, Version 1.0