Hama EWS-880 Bedienungsanleitung Seite 5

Radio icon
Flashing display
Constant display
No display
Note – Time settings
• If, during initial setup of the device, a DCF radio signal is not received within the first
few minutes, the search is aborted. The radio symbol disappears.
• If there are reception problems, we recommend leaving the clock to sit overnight, since
interference is generally less at night.
• In the meantime, you can start a manual search for the DCF radio signal at another
location or you can manually set the time and date.
• The clock automatically continues to search for the DCF radio signal on a daily basis
(2:00 a.m., 8:00 a.m., 2:00 p.m. and 8:00 p.m.). If the signal is received successfully,
the manually set time and date are overwritten.
• Press the RCC button (17) to start the manual search for the DCF radio signal.
Note – Manual search
• The manual search is automatically aborted after 6-16 minutes.
• Using the RCC button (10) frequently will drain the battery. We recommend only using
this function to seek out an optimal location for the device.
8
Searching for the DCF signal
Active
Successful – signal is being received
Error – signal search ended
Note – Summer time
• The clock automatically switches to summer time.
as summer time is activated.
Manually setting
• Press and hold the DISPLAY SET button (14) for approx. 3 seconds
to make the following settings one after the other:
• 12/24-hour format (5)
• Hours (5)
• Minutes (5)
• Seconds (only zeros possible) (5)
• Time zone (5)
• To select the individual values, press the CH+ button (11) or the MEM– button (15) and
confirm each selection by pressing the DISPLAY SET button (14).
• If you do not make an entry for 60 seconds, you automatically exit the setup mode.
Note – Time zone
• The DCF signal can be received over long distances, but always transmits the current
Central European Time in Germany. Make sure you account for the time difference in
countries with another time zone.
• If you are in Moscow, the time is 3 hours later than in Germany. This means that you
should set +3 for the time zone. The clock then automatically sets the time to 3 hours
after the DCF signal received or relative to the manually set time.
Alarm
• Press and hold the ALARM SET button (10) for approx. 3 seconds to set the time of the
alarm displayed. The hours display begins to flash.
• Press the CH+ button (11) or the MEM– button (15) to select the hour for the alarm time
and confirm your selection by pressing the ALARM SET button (10). The minutes display
begins to flash.
• Repeat the process to set the minutes for the alarm time.
• If you do not make an entry for 60 seconds, you automatically exit the setup mode.
• The alarm function is automatically activated when you set the alarm time.
appears on the display as long
DST
9