Commissioning; Appliance Handover; Recommissioning; Settings - STIEBEL ELTRON SHW 200 S Bedienung Und Installation

INSTALLATION

Commissioning

11. Commissioning
11.1 Commissioning
f Open a draw-off point until the appliance has filled up and f
the pipework is free of air.
f Adjust the flow rate. For this, observe the maximum permis- f
sible flow rate with a fully opened tap (see chapter "Specifi-
cation / Data table"). If necessary reduce the flow rate at the
butterfly valve of the safety assembly.
f Carry out a tightness check. f
f Turn the temperature selector to maximum temperature. f
f Switch the mains power ON. f
f Check the function of the appliance. f
f Check the function of the safety assembly. f

11.1.1 Appliance handover

f Explain the appliance function to users and familiarise them f
with its operation.
f Make the user aware of potential dangers, especially the risk f
of scalding.
f Hand over these instructions. f

11.2 Recommissioning

See chapter "Commissioning".
www.stiebel-eltron.com

12. Settings

12.2.1 Limiting the temperature selection
You can adjust the temperature selection limitation beneath the
temperature selector.
Factory setting: Limited to 60 °C
f Set the temperature selector to "cold" and isolate the appli- f
ance from the power supply.
f Remove the temperature selector and the control panel f
cover.
1
1 Limiter disc
2 Without limiter disc, maximum 82 °C
f You can set the limit to 45 °C / 60 °C by rotating the limiter f
disc. After removing the limiter disc, the maximum tempera-
ture can be set.
f Replace the control panel cover and temperature selector. f

13. Shutting down

f Disconnect the appliance from the mains at the MCB/fuse in f
the fuse box.
f Drain the appliance. See chapter "Maintenance / Draining the f
appliance".
2
SHW S | 25