Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION
Installation
Installation
f Fit the cylinder casing.
f
f Fit the cable grommet and control panel cover.
f
f Push on the temperature selector.
f
f If you use the "DHW circulation" connection to install a DHW
f
circulation line, you need to cut an opening in the cylinder
casing near the connection (indentation in the foam) for the
DHW circulation line.
f Remove the thermal insulation near the connection.
f
f Route the DHW circulation line through the aperture in the
f
cylinder casing and fit the DHW circulation line.
f Insulate the "DHW circulation" connection.
f
f Insert the supplied adaptor with flat gasket and an extension.
f
f Cover the hole in the cylinder casing with the adhesive rose
f
supplied.
f Fit the cover and the plinth trim of the cylinder casing.
f
10.2 Thermometer
f Insert the thermometer as far as it will go and align it.
f
www.stiebel-eltron.com
10.3 Signal anode
Material damage
!
The appliance must not be operated without a consump-
tion indicator or with a damaged one, otherwise water
will leak out once the anode is depleted.
1
1 Transport protection
2 Signal anode with consumption indicator
f Remove the transport protection.
f
f Check the consumption indicator for transport damage.
f
10.4 Water connection and safety assembly
10.4.1 Safety instructions
Note
Carry out all water connection and installation work in
accordance with regulations.
Material damage
!
When using plastic pipework, observe chapter "Specifi-
cation / Fault conditions".
Material damage
!
Operate the appliance only with pressure-tested taps.
Cold water line
Galvanised steel, stainless steel, copper and plastic are approved
materials.
A safety valve is required.
DHW line
Stainless steel, copper and plastic pipework are approved ma-
terials.
2
SHW S |
23
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
