Herunterladen Inhalt Inhalt Diese Seite drucken

Full-Stall; Rapid Decent Manoeuvres; Spiral - Airdesign eazy superlight Betriebshandbuch

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

As the glider surges forward slow it down with the brakes to avoid the possibility of an
asymmetric collapse. Always wait for the glider to be in front of you or above you when
releasing a fully deployed spin - never release the spin while the wing is behind you because
the glider would dive very far in front of you or even underneath.
m. Full-stall
This is an extreme manoeuvre that should rarely, if ever, be required.
To induce a full stall, pull both brake-lines down smoothly. Hold them down, locking your arms
under your seat until the canopy falls behind you and deforms into a characteristic crescent
shape. In spite of how uncomfortable it may feel as the glider falls backwards, be careful not to
release the brakes prematurely or asymmetrically. If the brakes are released while the glider is
falling backwards the surge and dive forwards is very fast and the glider may shoot in front and
even underneath you.
In a full stall the canopy will oscillate back and forth. To stabilise this, the pilot can release the
brakes slowly and for approximately 1/3 of the brake travel and then hold at this level. Holding
at this position allows the wing to refill slightly across the span. When releasing the brakes
without pre-filling the ears mostly will most probably hook in the lines and this can result in a
cravat.
After pre-filling the glider stabilizes its movements and the brakes can be leased until the glider
recovers speed and flies again.
ATTENTION: The full stall requires a lot of height and demands certain skills to recover. It is
important this manoeuvre is not practiced without qualified supervision.
It should preferably be practiced during a safety training course.
n.
The spiral dive is an effective way of making a fast descent. During the spiral dive the pilot and
glider will experience strong centrifugal forces which strain the glider. As such it should be
considered an extreme manoeuvre. Due to the rapid height loss during a spiral, pilots must
always take care that they have sufficient altitude before initiating the manoeuvre and that the
airspace is free around the pilot.
Initiation: Weight shift and smoothly pull on one brake (the same side you are weight shifting
into) so the glider goes from a normal 360-degree turn into a steep turn and from there into a
spiral dive. Once established in the spiral the descent rate and bank angle can be controlled
with weight shift and the releasing or pulling of inner brake. As the glider banks in front of the
pilot maintain the spiral by keeping the brake pressure constant, at this point weight-shift can
be neutralised. Descent is controlled by pulling more on the inner brake. A slight pull on the
outside brake helps to keep the glider stable.
Recovery: The EAZY recovers from a spiral spontaneously as soon as the brakes are released
and weight shift returns to neutral. To exit, allow the spiral to slow down for a turn or two by
slowly releasing the inner brake. Once the glider starts to exit the spiral, control your descent
rate and bank angle with weight shift and the outer and/or inner brake to prevent any strong
climbs out of spiral. Always finish a spiral dive at a safe altitude.
The EAZY does not show any tendency for a stable spiral. That means the glider does not
remain in spiral after releasing the brakes. If the glider should, in rare cases, remain in a stable

Rapid decent manoeuvres

i. Spiral
39

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Eazy

Inhaltsverzeichnis