Synq DMC.200 Bedienungsanleitung Seite 20

ENGLISH
MASTER
SW/LED
METER
MASTER VR
BOOTH VR
VR/SW/
Cross Fader
SW/CENTER
MIC1 LEVEL VR
MIC2 LEVEL VR
CUE PAN
VR
SLIDER
CUE PAN
VR
LEVEL
Fader Start
SW
ON(L)
Fader Start
SW
OFF(L)
Fader Start
SW
ON(R)
Fader Start
SW
OFF(R)
C.F CURVE
SW
(L)
C.F CURVE
SW
(CENTER)
C.F CURVE
SW
(R)
CC-ABSOLUTE (VR, LEVEL METER LED) TYPE
Control Change messages are sent with status 0xBn, where n is the channel, for the specified CC
controller. Thus the controller MIDI ID is indicated with the channel along with the CC number. The value
from 0x00 to 0x7F, directly related to the location of the controller.
＊ LEVEL METER LEDS
00~0B => ALL LEDS OFF
0C~17=>LED(-30) ON
18~23=>LED(-30, -20) ON
24~2F=>LED(-30, -20, -10) ON
30~3B=>LED(-30, -20, -10, -7) ON
3C~47=>LED(-30, -20, -10, -7, -4) ON
48~53=>LED(-30, -20, -10, -7, -4, -2) ON
54~5F=>LED(-30, -20, -10, -7, -4, -2, 0) ON
60~6B=>LED(-30, -20, -10, -7, -4, -2, 0, +2) ON
6C~77=>LED(-30, -20, -10, -7, -4, -2, 0, +2, +4) ON
78~7F=> ALL LEDS ON (-30, -20, -10, -7, -4, -2, 0, +2, +4, +7)
CC-RELATIVE (ENC) TYPE
Control Change messages are status 0xBn, where n is the channel, for the specified CC controller. Thus
the controller MIDI ID is indicated with the channel along with the CC number. The value 0x40 is the
reference value of the controller. This is an offset to 0x40 "one's complement" notation.
A message with data 0x43 indicates a positive change of 3.
A messages with data 0x31 indicates a negative change of 15.
SWITCH ON/OFF (SW,CENTER)
These messages are used for switches.
Control Change messages are sent with status 0x9n, SWITCH On and Off value are 0x7F and 0x00,
where n is the channel.
SYNQ
®
18/107
OPERATION MANUAL
2D/2D A2 6C
31 70
32 71
30/08/
6F/47/48/49
09/0A
35 74
36 75
34 73
33 72
1 40
2 41
3 42
4 43
7 46
6 45
5 44
DMC2000
00H：OFF
7FH：ON
00H：OFF
VR:00~7F
VR:00~7F
VR:00~7F
VR:00~7F
VR:00~7F
VR:00~7F
VR:00~7F
7FH：ON
00H：OFF
7FH：ON
00H：OFF
7FH：ON
00H：OFF
7FH：ON
00H：OFF
7FH：ON
00H：OFF
7FH：ON
00H：OFF
7FH：ON
00H：OFF