Synq DMC.200 Bedienungsanleitung Seite 12

ENGLISH
H. AUTO CUE: appears when the "auto cue" function is active. See SGL/CTN button (42).
I. RELOOP: shows when a loop is programmed. (repeating a particular area)
 RELOOP Flashing: Loop is programmed and currently playing.
 RELOOP on: Loop is programmed but not playing.
J. SINGLE: appears when the unit is set to play just one track at a time. When it is not shown, all tracks are
played without interruption. The function is controlled by the SGL/CTN button (42).
K. MP3 indicator: appears when an MP3-file is playing.
L. TRACK indicator: shows the number of tracks available in your current selection.
 Standard lookup: (no Q-Dbase) the track numbers in the current folder (M) are shown.
 Q-Dbase lookup: the track numbers that correspond to your Q-Dbase pre-selection.
M. FOLDER/SEARCH KEY indicator: the information depends on the lookup mode you selected.
 Standard lookup: (no Q-Dbase) the current folder number is shown.
 Q-Dbase lookup: the current search key (Art, Alb or Gen) is shown.
N. ELAPSED, TOTAL REMAIN: indicates that the time shown on the display is the track elapsed, remaining
or total remaining time.
O. MINUTE: Shows "minutes" time information of current track.
P. SECOND: Shows "seconds" time information of current track.
Q. FRAME: Shows "frame" time information of current track. (1 frame = 1/75
R. TIME BAR: has 2 functions:
 During normal playback: shows either time remaining or elapsed depending on the setting of the
TIME button. Starts flashing at the end of each track to alert the user to take action.
 During loop playback: shows the time remaining until the end of the loop. This visual aid helps you
to see where and when the seamless loop starts again.
S. PITCH DISPLAY: Shows the actual percentage of speed change, selected with the SPEED slider (28).
The small red colored padlock is shown when the pitch lock function (Master Tempo) is active.
CONNECTIONS
Some important notes for the USB-storage devices that you will connect:
Note 1: the hard disk must be formatted in FAT32! A hard disk formatted in NTFS (mostly drives with big
capacity) will NOT be recognized: such hard disk should be re-formatted in FAT32! (this can be done under
Windows, support can be found on the DMC2000 product page)
Note 2: the USB-slots on this player can each deliver 1A power to the connected hard disk. However we
suggest using a hard disk with separate power supply for better reliability.
Note 3: only WAV and MP3 files are recognized and can be played.
Note 4: for your convenience we strongly advice using the Q-DBASE indexer software, it simply mazkes life
a lot easier!
SIMPLE SETUP – 1 DECK
 Connect the balanced(5) or unbalanced(6) master to a power amplifier or powered speaker cabinets.
 Connect a USB-stick to USB1-input (13) or USB-harddisk to the USB2-input (3).
 If needed, connect a microphone to the mic1 (57) or mic2 (11) input.
 Connect the supplied power cord between the mains input (1) on the player and the mains socket.
 You are ready to play and mix the MP3/WAV files on your USB-storage. Have fun!
SYNQ
®
10/107
OPERATION MANUAL
th
sec.)
DMC2000