Swarovski Optik Z6/Z6i Bedienungsanleitung Seite 14

2.7 COVERING THE SWAROVSKI OPTIK RAIL
(SR VERSION ONLY)
3.
SIGHTING THE RIFLE
SCOPE IN
3.1 BASIC ALIGNMENT
To ensure perfect alignment of the scope to the
rifle, have a competent gunsmith mount the
scope.
The reticle has been factory-set to the mecha-
nical middle position. Prior to mounting you can
check the correct position of the reticle. To do
this, unscrew the screw-on caps of the elevation
adjustment turret and windage adjustment turret.
Now turn the respective knurled knob of the eleva-
tion adjustment turret and windage adjustment
turret clockwise until it reaches the stop. Then
turn the knurled knob again counter-clockwise
until it reaches the stop and count the clicks at
the same time.
Halve the number of clicks and you will have the
exact middle position. Repeat this procedure for
the second turret.
Note:
When mounting the rifle scope onto the rifle, ple-
ase make sure that you comply with the eye relief
specified (see technical data sheet).
3.2 ALIGNMENT OF THE SCOPE TO THE RIFLE
If the point of impact of the bullet deviates from
the aiming point, this can be easily and precisely
corrected by adjusting the elevation turret and the
windage turret of the scope.
Regardless of corrections, the middle point of
the reticle always stays in the middle of the field
of view.
26
Z6/Z6i / EN Z6/Z6i / DE
The cover provided serves
to protect the exposed rail
parts. It may be cut to the
required size and pressed
into the rail by hand.
Preparations for sighting the rifle scope in:
Before sighting the rifle scope in, please make
sure that the following parameters are set cor-
rectly:
- Parallax
- Diopter adjustment
- Level of magnification
To make adjustments, simply unscrew the screw-
on caps of the elevation and windage turrets.
When the shot is low
When the shot is high
When the shot is to the left
When the shot is to the right
The impact point correction per click can be
taken from the enclosed technical data sheet or
the information printed on the elevation or winda-
ge adjustment turret of your rifle scope.
Z6/Z6i / EN Z6/Z6i / DE
Turn the knurled knob
of the elevation turret
in the direction of H
(counter-clockwise).
Turn the knurled
knob of the elevation
turret in the opposite
direction to H (clock-
wise).
Turn the knurled knob
of the windage turret
in the direction of R
(counter-clockwise).
Turn the knurled knob
of the windage turret in
the opposite direction
to R (clockwise).
27