Operation - Swarovski Optik Z6/Z6i Bedienungsanleitung

2.

OPERATION

2.1 ADJUSTING THE FOCUS
Simply turn the dioptric correction ring to achieve
the best focus for your individual setting of the
reticle.
depend on the individual models. Please consult
the technical data sheet enclosed.
2.2 CHANGING THE MAGNIFICATION
of the setting. The soft, ribbed covering of the
adjustment ring has a nose for better orientation.
2.3 THE RETICLE IN THE 2
(EYEPIECE IMAGE PLANE)
If the magnification increases, then the reticle
remains the same size – the size of the image is
increased but not the size of the reticle. Even for
large magnifications only a little of the target is
covered. The reticle can only be used for estima-
ting the distance to a limited extent.
20
Z6/Z6i / EN Z6/Z6i / DE
First turn the dioptric cor-
rection ring all the way
to the left (counter-clock-
wise) and then to the right,
until the reticle is optimally
focused.
The adjustment ranges
You can set the desired
magnification by turning
the (stepless) magnificati-
on adjustment ring through
180°. The scale on the
adjustment ring allows
simple and easy reading
IMAGE PLANE
ND
2.4 PARALLAX
Your rifle scope is set to be parallax-free without
parallax turret at a target distance of 109 yards
(100 m). This means that at a distance of 109
yards (100 m), the image of the object aimed at
and the image of the reticle are in a single plane.
Please take into consideration:
With shots at distances greater or less than 109
yards (100 m), take care to position the eye care-
fully central to the scope. This will prevent shifting
of the impact point due to parallax errors.
2.5 OPERATION OF THE PARALLAX TURRET
(DEPENDING ON MODEL)
a) Rapid Adjustment
The target distances are printed on the parallax
turret from 50 m to ∞. Turn the parallax tur-
ret until the index point indicates the desired
distance. The parallax turret also features a
detent at 100 m, allowing you to feel when this
point has been reached, especially in twilight.
b) Precision adjustment
Set the magnification as high as possible and
turn the parallax turret until the image appears at
its sharpest. Now move the eye backwards and
forwards within the range of the exit pupil. If in
the process the reticle moves in relation to the
image, correct the distance setting until it is no
longer possible to discern any difference between
the movement of the reticle and the movement
of the image.
Z6/Z6i / EN Z6/Z6i / DE
Using the parallax turret,
you can adjust the opti-
mum focus for every target
distance thus preventing
aiming errors due to par-
allax.
21