Panasonic TY-WK42PV20 Installationsaleitung Seite 4

Components
Parts used to assemble the wall-hanging bracket
 Base upper and lower
fitting (2)
Parts used for installation
View of fully assembled fixture
L
Precautions for wall-hanging bracket fitting
♦ The wall-hanging bracket is for use in attaching a plasma display unit to a vertical wall for viewing.
Do not fit to any surface other than a vertical wall.
♦ To ensure correct plasma display performance and prevent trouble, do not fit at any of the following locations.
• Near sprinklers or fire/smoke detectors
• Where there is a risk of exposure to vibration or impact
• Near high-voltage wires or dynamic power supplies
• Near sources of magnetism, heat, water vapor or soot
• Locations exposed to air blown from heating equipment
• Where droplets of condensation from an air conditioner or other unit may form
♦ Fit using techniques suited to the structure and materials of the fitting location.
♦ Use commercially available screws with a nominal diameter of 6 mm (0.2 inches) that are suited to the wall
material (wood, steel frame, concrete etc.) you are fitting the bracket to.
♦ Ensure good air flow so that the ambient temperature does not exceed 40 °C (104 °F).
Failure to do this may cause heat to build up inside the plasma display, resulting in malfunction.
♦ Spread a soft blanket or cloth over the floor so that the plasma display and floor will not be marked or scratched
during the assembly and installation work.
♦ When screwing down the parts, ensure that the screws are neither insufficiently tightened nor over tightened.
♦ For the plasma display power supply plug, use a power supply outlet that can be reached easily.
♦ Take sufficient care and ensure safety around you when performing the installation work.
♦ Do not install the plasma display underneath ceiling lamps (spotlights, halogen lamps, etc.).
Otherwise, the cabinet may be bent or damaged by high heat.
12
 Bracket base left fitting
(1)
 Allen head countersunk
screw (4)
M8×32
 Dished toothed washer (4)
R
 Insulation spacer (4)
[The images shown in this manual are for illustrative purpose only.]
 Bracket base right fitting
(1)
 Screw for securing unit (long) (1)
Screw for securing unit (short) (1)
 Allen wrench (included tool) (1)
 Screw for
assembling the
fixture (8)
M5×10