Storch SSF 1200 Bedienungsanleitung Seite 49

Motor Safety Protection
Attention: To avoid motor damage, this motor should
be blown out or vacuumed regularly to keep dust
from interfering with normal motor ventilation.
1. Connect this tool to a 230 V / 50 Hz power sup-
ply.
2. If the motor won't start after pressing the On/Off
switch, turn the switch "OFF" immediately, un-
plug the tool and check the machine for failures.
3. If the motor suddenly stalls while milling, release
the On/Off switch and unplug the tool. The motor
may now be restarted.
4. This machine is equipped with a thermo switch.
This switch may trip due to the following reasons
and it protects the machine from damage:
• Motor Is Overloaded - Overloading can occur if
you make too many start/stops in a short time.
• The pressure applied to the machine is too high.
• The mains voltage is too high or too low. The
nominal voltage should not be more than 10%
above or below the nameplate voltage.
• Extension cable is too long
• Conductor cross section is too small
• Ventilation slots are clogged
Extension cable
NOTE: Make sure the proper extension
cord is used and is in good condition. Use
only 3-wire extension cords that have
3-prong grounding plugs and 3-pole re-
ceptacles that accept the machine's plug.
The use of any extension cord will cause some loss of
power. In order to keep the loss minimal and to avoid
overheating of the machine make sure that a mini-
mum conductor cross section of 2.5 mm² is used.
Before using the machine
CAUTION:
med during
ling are
Work in well-ventilated areas only and
wear personal protective equipment as
Caution!
well as dust masks as prescribed.
Unpacking
The SSF 1200 is shipped completely in one trans-
port case.
• Remove the case and all loose parts from the
carton.
• Check the case content for completeness and put
all parts to an accurate visual inspection.
• Immediately complain about missing or defective
parts.
Dust being for-
grinding and mil-
harmful to health.
WARNING: If any parts are missing do
not operate your grinding and restora-
tion cutter until the missing parts are
replaced. Failure to do so could result
Caution!
in possible serious injury.
List of Contents
• Milling cutter
pyramidal milling wheels
• diamond grinding disc
• Installation kit for diamond grinding disc (con-
tains: long clamp screw, washer, spacer, counter
wrench)
• Side Handle
• Allen key
• Wheel puller
• Universal vacuum cleaner connection adapter
• Transport case
• Instruction manual
NOTE: Make sure that the power circuit
voltage is the same as that shown on the
specification plate of the machine and
that switch is "OFF" before connecting
the machine to the power circuit.
Lock - Off Trigger Switch
On - Press the Safety Lock then squeeze the trigger
switch to start.
NOTE: If the Safety Lock is not pushed first then
the machine will not start. Off - Release the trigger
switch to turn off.
49
Duo SSF 1200
"ON/OFF" switch
with