Inserting Batteries; Test Button - Phottix Ares Benutzerhandbuch

Please Note
1. Phottix Ares receivers are designed to work in
camera and ash manual mode and have no
TTL functions.
2. Phottix Ares receivers will re hot shoe ashes
that are triggered from the center contact pin.
Some third party
auxiliary hot shoe pins will not trigger when
used on the Ares receiver hot shoe. Flashes will
trigger via sync cable if the ash has a sync port.
Tip:
Turn o all devices –
cameras, and Phottix Ares transmitters and
receivers - when connecting and disconnecting
devices.
4
ashes that trigger from
ashes/strobes,

Inserting Batteries

1. Press the battery cover in while pushing it
away from the Ares transmitter or receiver. The
battery cover will snap open.
2. Remove the battery cover from the Ares.
3. Insert AA batteries as shown inside the
battery compartment.
4. Replace the battery cover and push back into
the locked position.

Test Button

1. The Transmitter Test Button will test re
remote ashes/strobes.
2. To Test: Press the Transmitter Test Button –
ashes/strobes connected to Phottix Ares
receivers on the same channel will re.