Inserting Batteries - Phottix Odin Bedienungsanleitung

Inserting batteries

1. Press the battery cover in while pushing it away from
the Phottix Odin TCU or receiver. The battery cover
will slide open.
2. Remove the battery cover.
3. Insert AA batteries as shown.
3. Replace the battery cover and push back into the
locked position.
5. When the battery power icon on the TCU shows low
battery levels please change the batteries.
6. When the battery power on receivers is very low, the
LED will fl ash red light every 2 seconds. Please
change the batteries.
Turning the TCU and receiver on/off
1. To turn on the Phottix Odin TCU: Press and hold the
Power Button until an image appears on the LCD
screen. To turn off : Press and hold the Power Button
until the LCD screen goes blank.
2. To turn on the Phottix Odin receiver: Move the power
switch to the "ON" position. Turn off the receiver by
moving the power switch to the "OFF" position.
Groups and Channels
1. The Phottix Odin System has 3 groups: A, B, and C,
and 4 tranmission channels: 1, 2, 3, 4.
2. Receivers can be assigned both group and channel
designations.
3. The transmitter will allow power levels and changes
to be set for each group. Unless turned off on the
TCU, all receivers set to the same channel and group
will fi re.
The TCU
Connecting to the camera hot shoe
1. Turn off the camera.
2. Slide the Odin TCU into the camera's hot shoe mount.
3. Turn the TCU locking ring until tight.
4. Turn on the Odin TCU (see above).
5. Turn on the camera.
Functions
The TCU has two main function screens: TTL/Mixed and
Ratio.
TTL/Mixed allows groups A, B and C to be set to TTL,
5